18 en Diagrams | Control Panel |
|
|
3.5.1SDI2 Bus Wiring Recommendations
Use the following SDI2 bus wiring recommendations for SDI2 installation. The SDI2 bus is used by the GV4 Control Panel and corresponding modules to communicate with one another. Modules can be connected via home run, daisy chain, or single level
Figure 3.7: SDI2 Bus Wiring
Callout ᅳ Description
1 ᅳ Control panel
2 ᅳ SDI2 module
3 ᅳ Daisy chained wiring
4 ᅳ
5 ᅳ Home run wiring
| If the voltage at any device is below the minimum, you must add an auxiliary power supply to |
| the system to power these devices. |
|
|
i | Notice! |
The absolute lowest voltage for the SDI2 devices is 10 VDC at the device terminals when in | |
| normal operation, with a fully charged battery on the system. |
|
|
| Maximum cable lengths |
| The following rules must be followed when wiring the SDI2 bus. |
| – The SDI2 bus requires the use of |
| – Maximum overall cable length based on the table listed below: |
2012.12 02 F.01U.265.462 | UL Installation Instructions | Bosch Security Systens, Inc. |