Basic Saw Operations
Detent Override
To Engage:
1.Lift the miter detent trigger 1 (Figure 27).
2.Push the detent override clip 2 forward and latch in place over edge. Release miter detent trigger 1.
3.Move miter arm 3 to any position on the miter scale.
4.Lock the miter lock knob 4 to retain miter position.
To Disengage:
5.Loosen miter lock knob 4 and lift the miter detent trigger 1 to release the detent override clip 2.
FIG. 27
2
15
10 5
4
3 1
Sliding Base/Fence Extension
!WARNING Extend and use sliding base/fence when making severe bevel, severe miter or
compound cuts to provide sufficient (minimum 6”) spacing from hand to saw blade.
Sliding Base:
1.Remove hex wrench from storage position on left rear leg.
2.Loosen two (2) socket cap screws 5 in sliding base channel (Figure 28).
3.Extend sliding base/fence 6 to the desired position.
4.Tighten screws. Store hex wrench.
FIG. 28
6
5
50
45
40
35 |
|
30 | 25 |
|
Sliding Fence:
1.Unlock the fence locking lever 7 (Figure 29).
2. | FIG. 29 | 7 | |
Slide fence to proper position 8. | 8 | ||
3. | Relock fence in place. | ||
|
! CAUTION During transportation, sliding base and fence should always be secured in the full
in position.
54
