Basic Saw Operations
Workpiece Support
!WARNING Long workpieces have a tendency to tip over unless clamped down and properly
supported from underneath.
Clamps
Quick Action Clamp - This clamp easily secures a workpiece in any of six (6) clamp holes around the saw (Figure 21).
•Insert clamp post into clamp hole 1.
•Adjust screw rod 2 to proper height, if necessary.
•Press down on lever 3 to tighten clamp.
•Move the head assembly to check clearance with clamp.
•Pull up on lever to release clamp.
!WARNING There may be extreme compound cuts where clamp cannot be used. Support
with hand outside No Hands Zone. Do not try to cut short pieces that cannot be clamped and cause your hand to be in the No Hands Zone.
Conventional Clamps and other hold down devices can be used to hold the workpiece firmly against the table and the fence.
Long Workpiece Support
Blocks - Long pieces need extra support. The base height
Extension and Stock Stop - This attachment (accessory BB1204) allows extra support for the longer workpieces. Refer to the accessory instruction sheet for details (Figure 23). See page 74 for a complete accessory list.
FIG. 21
3
2
1
FIG. 22
(2) 2x4
(1) 1x4
50
FIG. 23
(BB1204)
50
5 4
40 35
5
25 | 20 |
45 | 40 | 35 | 30 |
50
45
40
35
50
