BM 2610007877
Adjustments
0° Bevel Stop – Adjustment procedure
!WARNING To avoid possible injury, disconnect plug from power
source before performing any assembly, adjustment or repair.
Adjusting 0° Bevel Stop
(Blade 90° to Table)
1.Pull up the bevel lock lever to loosen.
2.Loosen bolt heads “A” and “B” using a 10mm open end wrench or socket (with socket wrench). Loosen bolts at least one full turn (see Figure 23).
3.Loosen set screw “D” using the 4mm end of the 6/4mm hex key (provided with tool, but may also use a standard 4mm hex key). Loosen screw at least three full turns.
4.Place combination square on table and against blade (see Figure 22).
5.Using the 4mm end of hex key, turn set screw “C” and watch the saw blade tilt. Turn screw “C” until the blade is aligned (full contact) with the square’s body’s edge. After aligning, remove hex key.
6.Tighten set screw “D” using 4mm hex key.
7.Tighten bolt heads “A” and “B” using 10mm open end wrench.
8.Adjust bevel scale pointers (item 36 – page 9) to be in line with the bevel scale’s 0° lines.
9.Push down the bevel lock lever to lock.
Adjusting Bevel Stops
figure 23
22.
