Bosch Power Tools GCM12SD manual New Auxiliary Fence

BM 2610007877 04-10:BM 2610007877 04-10.qxp 4/26/10 8:13 AM Page 49

Saw Operations

Crown Molding Auxiliary fence

Auxiliary Fence - Using an Auxiliary Fence when cutting Crown molding flat on the table will reduce splintering of your workpiece and movement of small cut-off pieces. Remove the saw’s sliding fences (see page 29) before attaching the auxiliary fence.

Build auxiliary fence by following pattern below - Material: 3/4" x 1-1/2" wood.

Add 4 holes as dimensioned on pattern -or- Add holes following the next steps:

1)Cut wood to the outside dimensions shown and temporarily attach to saw’s stationary fence using two C-clamps.

2)Use 1/4" drill bit to drill first through existing holes in the rear of the stationary fence and then through the wood.

3)Remove wood, countersink the front of the wood and permanently attach to saw’s fence with hardware shown below.

OVERALL HEIGHT = 1-1/2"		OVERALL LENGTH = 26-1/16"
	7-15/32"		8"
3-1/16"		10-19/32"	3-1/16"
		5/16"
	Drill 4 Holes = 5/16" Diameter

Nut (need 4)	New Auxiliary Fence
	Board: 3/4" Wide x 1-1/2" High

Flat Washer (need 4)

5/16" Hole Through

1/2" Countersink

1/4" Flat Head Machine Screw x 2-1/2" Long (need 4)

Stationary	Saw Base	Top of Base
Fence
		and Table

Note: The Stationary Fence is permanently attached to the Saw Base (do not remove)

New Auxiliary Fence (assembled to Miter Saw)

Stationary	Saw Base	Top of Base
Fence
		and Table

figure 61

49.