
BM 2610007877
Saw Operations
Crown Molding Auxiliary fence
!WARNING When making a compound cut on a molding lying flat on the
table, narrow
|
|
|
|
|
|
|
|
|
|
|
|
Small | Stationary Fence | ||
|
|
|
|
figure 59. Cut-off piece Over fence
An auxiliary fence is used to add support to the cut- off workpiece such as large crown molding when cut flat on the table (see Figure 60). It will reduce splintering and movement of the unsupported
Making an Auxiliary fence: Required pieces:
Wood Board (described below)
4 – Flat Head Machine Screws – 1/4" diameter;
4 – 1/4" Flat Washers
4 – Nuts
1.Cut a nominal 1" x 2" wood board to a length of 26- 1/16" long. NOTE: 1 x 2" nominal equals 3/4" x
2.Drill four holes through the board using a 5/16" diameter drill bit. Countersink the holes deep enough so that the flat head screws will rest below the front work surface – use a 1/2" diameter drill bit (see Figure 61).
Remove the sliding fences from the tool – see page 29.
1.Place the flat head screws through the holes in the auxiliary fence, then the holes in the stationary fence on the tool.
2.Place the washers and nuts over the screw threads and against the stationary fence. Tighten nuts.
first-Time Use of the Auxiliary fence:
NOTE: The first time the auxiliary fence is used, it will be cut through by the saw blade – cutting through creates minimal clearance which reduces splintering on the workpiece. Set the miter angle and the bevel angle required before making the first cut. Clamp the workpiece, then make cut – example: compound cutting large crown molding flat on the table (see Figure 58).
Small | Auxiliary Fence |
figure 60. Cut-off piece Stopped by
Auxiliary fence
48.