Bostitch BTFP02028 owner manual Preparation For Use, Operating Procedures, Pre-Start Checklist Fig

Moving

The wheels and handle do not provide adequate clearance, stability, or support for pulling the unit up and down stairs or steps. The unit must be lifted or pushed up a ramp.

1. Grasp handle of compressor and tilt compressor back to rest on wheels.

Risk of Unsafe Operation. Ensure proper footing and use caution when rolling compressor so that unit does not tip or cause loss of balance.

2.When location is reached slowly lower compressor to ground. Always store compressor in a vertical position resting on the rubber bumpers and wheels.

Preparation For Use

Do not operate this unit until you read this instruction manual for safety, operation and maintenance instructions.

Pre-Start Checklist (Fig. 1)

1.Ensure the On/Off switch (A) is in the OFF position.

2.Plug the power cord into the correct branch circuit receptacle. See Voltage and Circuit Protection under Installation.

3.Ensure air tank is drained, see Draining Air Tank under Maintenance.

4.Ensure the drain valve (H) is closed.

5.Ensure safety valve (G) is functioning properly, see Checking Safety Valve (G) under Maintenance.

6.Turn the regulator knob (D) out counterclockwise until fully closed. Ensure Regulated

Pressure Gauge (C) reads 0 psi.

7.Attach hose and accessories. NOTE: Always use a minimum 3/8" (9.5 mm) or greater air hose rated at 300 psi.

Risk of unsafe operation. Firmly grasp air hose in hand when installing or discon- necting to prevent hose whip.

Risk of unsafe operation. Do not use damaged or worn accessories.

Risk of Bursting. Too much air pressure causes a hazardous risk of bursting. Check the manufacturer’s maximum pressure rating for air tools and accessories. The regu- lator outlet pressure setting must never exceed the maximum pressure rating of the tool or accessory.

Operating Procedures

Start-up (Fig. 1)

1.Follow Pre-Start Checklist under Preparation for Use.

2.Move the On/Off switch (A) to the ON position and allow tank pressure to build. Motor will stop when tank pressure reaches cut‑out pressure.

Risk of Property Damage. Compressed air from the unit may contain wa­ter condensation and oil mist. Do not spray unfil­tered­ air at an item that could be damaged by moisture. Some air oper­ated­ tools or de­vices­ may require filtered air.

Read the instruc­tions­ for the air tool or device.

3. Adjust regulator (D) to desired setting. See Regulator under Features.

Shut-down (Fig. 1)

1.Move On/Off switch (A) to the OFF position. NOTE: If finished using compressor, follow Steps 2–6.

NOTE: When the unit has been turned off, it is normal to hear a short hiss of air being released.

NOTE: Unplug unit when not in use.

2.Turn the regulator knob (D) counterclockwise until fully closed. Ensure Regulated Pressure

Gauge (C) reads 0 psi. Push knob in to lock in place.

3.Remove hose and accessory.

Risk of unsafe operation. Firmly grasp air hose in hand when installing or disconnecting to prevent hose whip.

4.Drain the air tank, see Draining Air Tank under Maintenance. Ensure Air Tank Pressure

Gauge (B) reads 0 psi.

11