MAINTENANCE and LUBRICATION
Maintenance and Lubrication Schedule (continued)
|
|
|
|
|
| continued |
| Carrier plate wear strips | Clean and lubricate. Apply |
|
|
| ||
| 8 Weeks | Clean ramp and ramp mounting area (ensure | Clean and remove debris or obstructions | |
| or 200 | no debris in area to obstruct stowing ) |
| |
| Cycles | Inspect ramp for wear, damage or any abnor- | Correct as needed | |
|
|
| ||
|
|
| mal condition. |
|
|
|
|
|
|
Perform all procedures listed in previous section also
1Year or
1250
Cycles
Remove motor cover and clean dirt and other foreign debris
Remove motor cover and inspect:
•Harness cables, wires, terminals and con- nections for securement or damage
Drive gear
Motor guide rails
Manual release CAM
Drive chain
Adjust chain tension
Inspect
Mounting
Antiskid
Blow out with air compressor
Re secure, replace defective parts or otherwise correct as needed.
Apply Grease - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Adjust as needed
Re secure, repair or replace or otherwise cor- rect as needed
Check to see that the ramp is securely an- chored to the vehicle and there are no loose bolts, broken welds, or stress fractures.
Replace decals if worn, missing or illegible. Replace antiskid if worn or missing.
Consecutive
8 Week or
200Cycle Intervals
Repeat all previously listed inspection, lubrica- tion and maintenance procedures at 8 week or 200 cycle intervals (or per vehicle maintenance schedule).
Page 32
