INSTALLATION
1
INSTALLATION
Specifications
Width: 27 ¼”
Height: 35 ½”
Depth:
28 ⅝”
Weight:
225 Pounds
Flue Size: 3” or 4 “
Hopper Capacity:
90 Pounds (Corn)
(This will vary depending on fuel)
EPA Status: Exempt
Maximum BTU Input:
50,000 BTU with whole
corn
Approved Installations
Alcove, Conventional, Mobile Home
Preparation
Factory packaging must be removed, and some
minor assembly work is required prior to
installation and use. Access to the rear and
sides of the stove will be necessary at some
point in time so be sure to leave ample room for
access, otherwise, be prepared to move the
stove when necessary.
Install the ceramic Brick Panel onto the rear
combustion wall. THIS IS A REQUIRED
COMPONENT. The Brick Panel is fragile, so
handle with care at all times. Your stove warranty only covers this item from thermal breakage. Impact damage
resulting from dropping or accidental abuse is not covered.
AUGER INSTALLATION: Install the auger into the auger tube as shown in
Figure 2. The flat face of the auger is toward the front of the stove, and the
beveled edge will go into the auger tube. Make sure the auger is all the way
to the rear and is engaged or seated properly.
STIR ROD & BURN POT INSTALLATION: The Burn Pot must
be set into the Burn Pot Holder with the fuel spreader towards
the rear of the stove, as shown.
Insert the stir rod into the burn pot with the beveled connector
toward the left. Align the beveled segments so that the holes on
each piece align, and insert the cotter pin.
Pressing the Auger Feed button while the stove is off rotates the
stir motor shaft. This will assist you in aligning these two pieces.