OPERATING YOUR BREVILLE Hemisphere™ Control Blender
Step 4
Plug power cord into a 110/120V power outlet and turn on.
Step 5
Press the 
button on the far left of the control panel to turn the blender on.
The 
button will illuminate and flash. The LCD timer screen will illuminate with ‘00’ displayed.
NOTE
Flashing light indicates ready to operate. Avoid any contact with moveable parts while in operation.
NOTE
Do not fill the blender jug above the ‘MAX’ line. When the blender jug is filled at or near the ‘MAX’ line place one hand on the blender lid to avoid displacement of the lid during operation.
Step 6
Select the required speed (1 to 5) by pressing the corresponding speed button. The blender will start to operate and the selected speed
button will illuminate. The 
button will illuminate and cease to flash.
The ‘Stop’ button will illuminate and flash. The LCD timer screen will start counting up in one second increments until 60 seconds is reached.
NOTE
Operate the blender only for the appropriate amount of time required – do not over blend.
Step 7
When 60 seconds is reached, the blender will automatically stop blending and the selected speed button and ‘Stop’ button
illumination will go out. The 
button will illuminate and flash. After a few seconds the LCD timer screen will revert to ‘00’.
NOTE
•The Breville Hemisphere™ Control Blender will automatically stop blending after 60 seconds
(1 minute). This is a safety feature and restricts wear on the motor.
•To stop blending at any time, press the ‘Stop’ button or the selected
speed button. The 
button can also be pressed, but this will also turn the appliance off and all illuminations will go out.
•The speed can be changed at any time during the blending process. Each time a new speed is selected its button will illuminate and the previous speed button illumination will go out. The number of seconds on the LCD timer screen will continue to count upwards to
60 seconds unless interrupted.
Step 8
The Breville Hemisphere™ Control Blender features two additional functions, ‘ICE CRUSH’ and ‘SMOOTHIE’. These two pre- programmed cycles automatically adjust the blending time and speeds to optimise blending results. Select the required function by pressing the corresponding function button. The blender will start to operate and the selected function button
will illuminate. The 
button will illuminate and stop flashing. The ‘Stop’ button will illuminate and flash. The LCD timer screen will start counting down in one second increments until ‘00’ is displayed.
12
BBL605XL_IB_A11_FA.indd 12 | 9/08/11 10:20 AM |
