
BLUE FLAME BURNER MAINTENANCE
Cleaning the Grill
Caution: To prevent injury, do not clean a hot grill.
Note: Do not use a commercial cleaner on the cooking grids. Do not brush grids while they are hot.
For baked on residue use a BRASS (NOT STEEL) brush on the cooking grid and other components.
Burn Off
This process is much like that used in
Caution: Do not open the grill during the burn off process. Opening the grill during the burn off process may cause a sudden grease fire flare up that could burn your face and arms. Wait until the grill has cooled before opening.
Grease Tray
Empty periodically. Replacement tray liners can be purchased at most supermarkets where disposable aluminum baking pans are displayed.
Burner (Venturi) Tubes
The burner (venturi) tubes allow air and gas to mix prior to burning, thus ensuring an efficient flame. Spiders or other small insects may build webs or nests inside the tubes obstructing air flow. Fire, or flashback, can occur, in and/ or around obstructed burner (venturi) tubes and can cause damage to components beneath the grill or an unsafe condition. To reduce risk, inspections and cleaning should be performed at least twice monthly when spiders are active. If the grill has been unused for an extended period of time inspect the tubes before using the grill.
1.Turn gas knob to HI. Close lid and allow the grill to burn for ten minutes, or until no smoke is present. Do not allow the grill to burn for more than 30 minutes.
2.Turn gas knob and supply to OFF and allow the grill to cool.
3.Wipe COOL grill with a damp cloth to remove soot.
Grill Bottom
Periodically remove cooking grids and
Blue Flame Burner Maintenance
Visually inspect the burner flames with each use. Five minutes after lighting, the flames should be blue and have well defined cones. See Figure 36. See the troubleshooting section if the flames are yellow or lift off the burner.
Stainless steel burners often turn reddish brown after use. This does not effect the performance of the grill. When cleaning the interior of the grill, remove the burners and clean with a brass brush. Wash with water and a mild detergent.
Clean burner (venturi) tubes as follows:
1.Remove the cooking grids and briquet rack (R3B only).
2.Remove the burner from the grill.
3.Use a small flexible brush to remove any debris from the burner (venturi) tube.
4.Flush with water.
5.Allow the burner (venturi) tube to dry before reinstalling.
6.Reinstall the burner, briquet rack and briquets and cooking grids.
Exterior
Clean regularly with a solution of mild detergent and hot water.
Char-Master Briquets
If the briquets did not come clean during burn off, after cool- ing turn them over. The residue will burn off during
Correct Flame Pattern | Incorrect Flame Pattern |
Figure 36
Page 44 |