Error Messages in the Status Monitor
file:///C|/Documents%20and%20Settings/mcampbell.AM/My%20Documents/ADS2000solutions/chapter7_2.html[3/11/2013 10:23:48 AM]
Error Messages in the Status Monitor
The Status Monitor will report problems with the machine. Take the proper action by referring to the following table.
If you want to turn the status monitor on, see Monitor the Status of the Machine from Your Computer (Windows®) or
Monitor the Status of the Machine from Your Computer (Macintosh) .
Error message Cause Action
Ready —The machine is ready to scan.
Sleep The machine is idle and the amount of
time specified by the Sleep Time setting
has elapsed.
Do one of the following:
•Press any key.
•Open the Top Cover.
•Load your document.
Offline The machine is not connected to the
computer.
Connect the machine to the computer and turn on
the machine by opening the Top Cover.
Out of Memory The machine's memory is full. Do one of the following:
•Press any key.
•Turn the machine off and then on by
unplugging the machine from the AC power
outlet and then plugging the machine in again.
Replace Pad The Separation Pad has been used over
50,000 times.
Replace the Separation Pad with a new one.
Scanning errors may occur if you do not replace
the part. See Replace the Separation Pad.
Replace Roller The Pick-up Roller has been used over
50,000 times.
Replace the Pick-up Roller with a new one.
Scanning errors may occur if you do not replace
the part. See Replace the Pick - up Roller.
Replace Parts Both the Separation Pad and the Pick-up
Roller have been used over 50,000
times.
Replace the Separation Pad and the Pick- up
Roller with new ones. Scanning errors may occur
if you do not replace the parts. See Replace the
Separation Pad and Replace the Pick-up Roller.
Cover is Open Front Cover is open. Do one of the following:
•If the error occurred while the machine was in
standby mode, see Front Cover is Open in LED
Indications.
•If the error occurred while scanning, see Front
Cover is Open in LED Indications.
Scan Unable The machine is warming up. Correct the error. See LED Indications and
Service Call Indications.
Unusable Device An unusable device is inserted in the
USB port.
Disconnect the device. Turn the machine off and
then on by unplugging the machine from the AC
power outlet and then plugging the machine in