GETTING READY ————————————————————————————————————————————

jMake sure that the thread is passed into the thread take-up lever as shown below.

a

aThread take-up lever

Memo

zIf the needle is not raised, you cannot pass the thread into the thread take-up lever. Be sure to press the needle position button to raise the needle before passing the thread into the thread take-up lever.

kPassguide.the thread behind the needle bar thread The thread can easily be passed behind the needle bar thread guide by holding the thread in your left hand, then feeding the thread with your right hand, as shown.

a

aNeedle bar thread guide

lLower the presser foot lever to lower the embroidery foot.

a

aPresser foot lever

mPull the end of the thread, which has been passed through the needle bar thread guide, to the left, then pass the thread through the notch of the thread guide (1), and then firmly pull the thread from the front and insert it into the slit of the thread guide disk marked "7" all the way (2).

Make sure that the thread passes the notch of the thread guide.

b

a

aNotch of the thread guide

bThread guide disk

nCut the thread with the cutter on the left side of the machine.

a

aThread cutter

40