Attaching the Embroidery Frame
This section describes how to attach the embroidery frame.
Attaching the embroidery frame
aWind the embroidery bobbin thread onto the bobbin and set it into the bobbin case.
•For details, refer to "Winding/Installing the Bobbin" (page 29).
bRaise the presser foot lever.
a
aPresser foot lever
cPress 
(Needle position button) once or twice to raise the needle.
a
aNeedle position button
dPass the embroidery frame under the presser foot while raising the presser foot lever even further.
CAUTION
●Do not touch the start/stop button or needle position button. If one of the buttons is accidentally pressed, the machine will move and your finger may be pricked with the needle or the needle may break.
Firmly insert the embroidery frame guide into | 1 |
ethe embroidery carriage frame holder from the |
|
top.
Line up the embroidery frame guide tabs and the embroidery carriage frame holder slots and push in until it clicks and stops.
a
b
aEmbroidery frame guide tabs
bEmbroidery carriage frame holder slots
XThe embroidery unit is attached.
Note
zBe sure to insert both pins. If only the forward or the back pin is inserted, the pattern may not turn out correctly.
CAUTION
●Correctly set the embroidery frame into the embroidery frame holder. Otherwise, the embroidery foot may hit the embroidery frame, resulting in injury.
Attaching the Embroidery Frame 47