GETTING READY—————————————————————————————————————————————————————————————————————————————————————————————————————

bCut the thread with the thread cutter on the left side of the machine.

a

aThread cutter

Note

●When using thread that quickly winds off the spool, such as metallic thread, it may be difficult to thread the needle if the thread is cut.

Therefore, instead of using the thread cutter, pull out about 80 mm (approx. 3 inches) of thread after passing it through the thread guide disks (marked “7”).

1

a80 mm (3 inches) or more

cLower the needle threader lever on the left side of the machine, and then slowly return the lever to its original position.

a

aNeedle threader lever

XThe thread is passed through the eye of the needle.

Note

●If the needle was not completely threaded, but a loop in the thread was formed in the eye of the needle, carefully pull the loop through the eye of the needle to pull out the end of the thread.

CAUTION

●When pulling out the thread, do not pull it with extreme force, otherwise the needle may break or bend.

24