Checking the needle
Sewing with a bent needle is extremely dangerous since the needle may break while the machine is being operated.
Before using the needle, place the flat side of the needle on a flat surface and check that the distance between the needle and the flat surface is even.
a
b
aFlat side
bNeedle type marking
a
aFlat surface
If the distance between the needle and the flat surface is not even, the needle is bent. Do not use a bent needle.
a
aFlat surface
Replacing the needle
Replace the needle as described below. Use the screwdriver and a correct needle, as described in
“Checking the needle”. | 1 |
|
aPress 
(needle position button) once or twice to raise the needle.
aNeedle position button
bTurn off the sewing machine.
CAUTION
●Before replacing the needle, be sure to turn off the sewing machine, otherwise injuries may occur if the start/stop button is accidentally pressed and the machine starts sewing.
cLower the presser foot lever.
a
aPresser foot lever
CAUTION
●Before replacing the needle, place fabric or paper under the presser foot to prevent the needle from falling into the hole in the needle plate.
31