CHAPTER 4 OPTIONS
4-33
✒ Note
The order to fasten the screws is, top right, top left, bottom right and bottom
left as viewed from the right hand side of the printer. If the screws are not
fastened in that order, the Duplex unit may not close completely or the Multi-
purpose tray may not work correctly.
☛
☛☛
☛ 8. If the Duplex unit is not installed, skip this step and go to step 9.
If the Duplex unit is installed, the plastic edges on each side of the unit must
be removed. The edges are held in place by four small posts. Twist the
edges to break the posts and remove them from the unit.
ZAEP290E
Fig. 4-54
☛
☛☛
☛ 9. Slide the Multi-purpose tray into the printer by aligning the grooves of the
right and left sides of the Multi-purpose tray onto the rails inside the holder.
ZAEP300E
Fig. 4-55