Configuring your machine for a wireless network (For MFC-8890DW)

Configure your machine for a wireless network

IMPORTANT

•If you are going to connect your Brother machine to your network, we recommend that you contact your system administrator prior to installation. You must know your wireless network settings before you proceed with this installation.

• If you have previously configured the wireless settings of the machine, you must reset the network LAN

3

settings before you can configure the wireless settings again. Press Menu, 7, 0 for Network Reset, press 1 for Reset and then choose 1 for Yes to accept the change. The machine will restart automatically.

Using the Setup Wizard from the control panel

You can configure your Brother machine by using the Setup Wizard function. This is located in the Network menu on the machine’s control panel. See to the steps below for further information.

a Write down the wireless network settings of your access point or wireless router. If you do not know them, contact your network administrator or the manufacture of your access point/router.

Check and record the current wireless network settings.

Network name:(SSID, ESSID)

Communication Mode

Authentication method

Encryption mode

Network key 4

Infrastructure

Open system

WEP 2

 

 

 

NONE

—

 

 

 

 

 

Shared key

WEP 2

 

 

WPA/WPA2-PSK 1

AES

 

 

 

TKIP 3

 

 

LEAP

CKIP

 

 

 

 

 

 

EAP-FAST/NONE

AES

 

 

 

 

 

 

EAP-FAST/MS-CHAPv2

TKIP

 

 

EAP-FAST/GTC

 

 

 

 

 

 

Ad-hoc

Open system

WEP 2

 

 

 

NONE

—

 

 

 

 

31