Wireless configuration for Windows® using the Brother installer application (For
l If the LCD shows Connected, the machine has successfully connected to your access point/router. You can now use your machine in a wireless network.
If the LCD shows Connection Error, a session overlap has been detected. The machine has detected more than one access point/router on your network with the SecureEasySetup™ mode, the
If the LCD shows No Access Point, the machine has not detected your access point/router on your
network with the SecureEasySetup™ mode, the
If the LCD shows Connection Fail, the machine has not successfully connected to your access point/router. Try starting from step i again. If the same message is indicated again, reset the machine back to the default factory settings and try again. (For resetting, see Restoring the network settings to factory default on page 123.)
LCD messages when using the SES/WPS/AOSS™ control panel menu
LCD shows | Connection status | Action | |
| Searching or accessing the access |
| |
Setting WLAN | point, and downloading settings from the | — | |
| access point |
| |
|
|
| |
Connecting SES |
|
| |
Connecting WPS | Connecting the access point | — | |
Connecting AOSS |
|
| |
|
|
| |
Connected | Connection succeeded. | — | |
|
|
| |
|
| Check that only one router or access point has | |
Connection Error | Session overlap has been detected. | the SecureEasySetup™ mode, the | |
Protected Setup mode or AOSS™ mode enabled | |||
|
| ||
|
| and try starting from step i again. | |
|
|
| |
No Access Point | The access point detection failed. | Move the machine closer to your access | |
point/router and try starting from step i again. | |||
|
| ||
|
|
| |
|
| 1 Try starting from step i again. | |
Connection Fail | Connection failed. | 2 If the same message continues, reset the | |
machine back to the factory settings and try | |||
|
| ||
|
| again. | |
|
|
|
54