USER’S GUIDE
Test Print Mode
The machine has the following test print mode. Follow these steps:
1.Make sure that the top cover is closed.
2.Hold down the switch and turn on the power switch. Keep the switch depressed until the Drum lamp comes on.
The Drum lamp lights to indicate that the machine is in the test print mode.
3.Press the switch again to execute the test print or hold down the switch to select another option and release the switch to execute the selected option.
The test print modes are listed below:
Lamp Lit | Choice | Function |
Drum | Test sample page | The machine prints a test sample page. |
|
| The machine returns to the ready status after |
|
| printing. |
Alarm | Print Config & Print | The machine prints the current configuration of |
| Fonts I | the machine and a list of the internal fonts. |
|
| The machine returns to the ready status after |
|
| printing. |
Ready | Factory Reset | The machine is restored to the factory setting |
|
| and permanent fonts and macros are cleared. |
|
| The machine returns to the ready status after |
|
| printing. |
Data | Hex Dump Print | The machine can print data as hexadecimal |
|
| values, so that you can check data errors and |
|
| problems. To exit from this mode, you have to |
|
| turn off the machine. |
