Brother MFC7150C, MFC7160C owner manual Remote Commands, Details Operation

86 C H A P T E R T E N

Remote Commands

Follow the commands below to access features remotely. When you call the MFC and enter your Remote Access Code (1 5 9 ), the system will signal you with two short beeps to enter a remote control command.

Remote Control Commands					Details Operation
95			Changing Fax Forwarding
			/Paging setting
		1		OFF	If you hear one long beep, the change is accepted. If you hear
		2		Fax Forwarding	three short beeps, you cannot change it because the conditions
					have not been met (Example: registering paging number). You
		3		Paging
					can register your fax forwarding number by using 4. FAX
		4		FAX FWD No.
					FWD NO (see page 87). Once you have registered the
					number, the MFC will change automatically to FAXFWD:ON
					mode. Then retrieve a Memory Status List by entering 961
					(see page 87) to make sure that the Fax Forwarding number
					you registered is correct in the List.
		6		Fax Storage ON	You can turn FAX STORAGE ON or OFF.
	7			Fax Storage OFF
96			Retrieve FAX
		1		Memory Status List	Enter the number of a remote fax machine to receive the
		2		Retrieve all faxes	Memory Status List or stored fax message(s). (See page
					86.)
		3		Erase fax from the	If you hear one long beep, you can erase fax message(s)
				memory	from the memory.
97	Check the receiving status
	1			FAX	You can check whether your MFC has received any fax
					message(s). If yes, you will hear one long beep. If no, you
					will hear three short beeps.
98			Change Answer Mode
			1	TAD	If you hear one long beep, you can change the Answer
			2	FAX/TEL	Mode. If you hear three short beeps, you cannot change it.
			3	FAX
90			Exit		After a long beep, you can exit remote control.