Error Message

Cause

 

Remedy

 

 

 

 

 

 

INTERFACE

This message appears if the wrong

Windows®

 

 

ERROR!

port is selected.

Under “Print to the following

 

 

port” in the printer Properties

 

 

dialog box, select “PTUSB:” for

 

 

the USB connection.

 

 

 

If two or more of the same

 

 

P-touch models are con-

 

 

nected

through their

USB

 

 

ports, instead of “PTUSB:”,

 

 

select

“PTUSB

(PT-

 

 

2600/2610-XXXXXXXXX):”

 

 

(where XXXXXXXXX is the

 

 

serial number). The serial

 

 

number is written above the

 

 

barcode on the silver label

 

 

attached to the bottom of

 

 

the P-touch.

 

 

 

Macintosh

 

 

 

 

In the Chooser, select the PT-

 

 

2600/2610 as the printer.

 

 

 

 

LENGTH

• This message appears if the text is

• Shorten the text to less than 3’

LIMIT!

longer than 3’ 3 1/3” (1 meter) when

3 1/3” (1 meter) before trying

 

you try to print.

to print.

 

 

 

 

 

 

• This message appears if the Length

• Set the label length between

 

function is used to set a label

1.6” (4.0 cm) and 11.8” (30.0

 

length that is less than 1.6” (4.0

cm).

 

 

 

cm) or more than 11.8” (30.0 cm).

 

 

 

 

 

 

 

• This message appears if the Tab

• Set the tab length so that it is

 

Length function is used to set a tab

less than 11.8” (30.0 cm).

 

 

length that is more than 11.8”

 

 

 

 

(30.0 cm).

 

 

 

 

 

 

LINE

This message appears if the number

Reduce the number of lines or

LIMIT!

of lines in the text is greater than the

install a tape of greater width.

 

maximum number of lines possible

 

 

 

 

for the installed tape.

 

 

 

 

 

 

MEMORY

This message appears if you try to

Delete an unwanted file to make

FULL!

store a text file after the maximum

room for the new one.

 

 

number of characters has already

 

 

 

 

been stored in the memory.

 

 

 

 

 

 

 

 

117

Page 124
Image 124
Brother PT-2600 manual Windows, Macintosh