Brother QL-650TD manual „Cutter, „Installation/Storage, „DK Roll DK Label, DK Tape

Caution

„Cutter

Follow the followings to avoid personal injury and damage of the printer.

Do not touch the blade of the cutter unit. Do not apply excessive pressure to the

Do not open the top cover whencutter unit. operating the cutter unit.

„Installation/Storage

Follow the followings to avoid personal injury and damage of the printer.

When using the printer, do not place it	Do not place any heavy objects on top of
on a unstable environment, such as	the printer.
dilapidated table or top of the shelf.

„DK Roll (DK Label, DK Tape)

Follow the followings to avoid damage of the printer.

11

Introduction

STEP

1

Before using the printer

STEP

Be careful not to drop the DK Roll.

DK Roll uses thermal paper and thermal film so that the color of the label will fade by sunlight or heat. Do not use DK Roll when you use them for outdoor and other circumstances which requires their durability.

Depending on the location, material, and environmental conditions, the label may have the difficulties to peel or unpeel, or the color of the label will be changed or transferred to other objects.

In prior to adhere the label, check the environmental condition and the material, and then test the label by affixing a small piece of it to an inconspicuous area of the intended surface.

2

only this printer	(No PC)
Using

„Battery

Follow the followings to avoid liquid leakage, heat, rupture of the battery.

STEP

3

PC

Do not insert the battery with the opposite pole direction to the instruction.

Remove the battery from the printer immediately at the end of its duration.

Do not solder the battery directly.

Do not use, expose, or keep the battery under the direct sunlight or to extremely high temperatures and humidity.

Do not wet the battery with water.

Do not drop or throw the battery to damage it.

Do not affect ultrasound vibration to the battery. The internal shorts may be occurred inside of the battery.

to your	For Windows
Connecting	For Macintosh

STEP

4

Maintenance and Troubleshooting