Brother QL-650TD manual Replacing the lithium clock battery

7 Once set in the correct position, tighten the screw which holds the cutting blade unit in place.

8 Set the DK Roll and close the DK Roll cover. For details, refer to Î"Setting the DK Roll" in page 23.

Replacing the lithium clock battery

A lithium battery is supplied in order to maintain the settings for the internal clock when the printer unit is not plugged-in to a normal power supply. If the clock settings need to be reset every time the printer unit is unplugged from its normal power source, then the battery must be replaced.

For the lithium battery for replacement, purchase CR2032 (recommended manufacturer: Hitachi Maxell, Ltd., FDK Corporation, Matsushita Electric Industrial Co.,Ltd., Sony Corporation, Toshiba Corporation and VARTA Microbattery Inc.).

57

Introduction

STEP

1

Before using the printer

STEP

2

this printer PC)

•Use only the authorized battery for the printer.

•Dispose in accordance with all applicable federal, state, and local regulations.

•When storing or discarding the battery, wrap it with adhesive cellophane tape etc. to prevent it from short- circuiting.

•It is recommended to replace the battery every two years.

Example of grounding of battery

Adhesive cellophane tape etc.

Battery

only	(No
Using

STEP

3

PC Windows

1 Turn OFF the power of this printer and pull the power cord out of the outlet.

2 Open the DK Roll cover and pull up the roll release lever to the up position and remove the DK Roll.

to your	For
Connecting	For Macintosh

STEP

4

Maintenance and Troubleshooting