Chapter 1
Installing the Printer Driver and the Software for
The
USB cable connection
Wireless network connection
When using a wireless network, please read from Before You Begin below to Choosing Your Wireless Install Method.
When using a USB cable, please read from Installation Procedure (Using USB Cable/Wireless Network) uu page 12.
Before You Begin
First you must configure the wireless network settings of your printer to communicate with your network access point/router. After the printer is configured to communicate with your access point/router, computers on your network will have access to the printer. To use the printer from these computers, you will need to install the drivers and software. The following steps will guide you through the configuration and installation process.
If you are going to connect the printer to your network, we recommend that you contact your system administrator prior to installation. You must know your wireless network settings before you proceed with this installation.
If you have previously configured the printer's wireless settings, you must reset the network settings before you can configure the wireless settings again.
1Press and hold the 
(Power) button to turn the printer off.
2Press and hold the 
(Feed)
button and the 
(Power) button until the POWER, STATUS and BATTERY indicators start blinking in orange.
3While pressing the 
(Power) button, press the 
(Feed) button once.
4Release the 
(Power) button and the 
(Feed) button at the same time.
Note
To achieve optimum results with normal everyday document printing, use the printer as close to the network access point/router as possible with minimal obstructions. Large objects and walls between the two devices as well as interference from other electronic devices can affect the data transfer speed of your documents.
Due to these factors, wireless may not be the best method of connection for all types of documents and applications.
The maximum processing speed is possible when using USB.
10