•If your access point is set to not broadcast the SSID, you can enter the SSID manually by clicking the [Advanced] button. Follow the on-screen instructions for entering the [Name (SSID)], and then click [Next].

g Enter the [Network Key] you noted in MEMO uu page 11 and then click [Next].

Setting Up the Printer

• If you want to manually assign an IP address to the printer, click [Change IP Address] and enter an IP address that is 1 compatible with your network.

•If the wireless setup failure screen appears, click [Retry].

i Disconnect the USB cable connecting the computer and the printer and then click [Next].

Wireless setup is now complete.

Go on to j to install the printer driver and the software.

j Choose the printer from the list, and then click [Next].

Note

If your network is not configured for authentication and encryption, the [ATTENTION!] screen will appear. To continue configuration, click [OK] and go to h.

h Confirm the wireless network settings and then click [Next]. The settings will be sent to your printer.

Note

•The settings will remain unchanged if you click [Cancel].

Note

•If your wireless settings fail, the [Wireless Device Setup Wizard] screen appears. Follow the on-screen instructions to complete the wireless configuration.

•If you are using WEP but your printer is not found, make sure you entered the WEP key correctly.

k Follow the on-screen instructions to complete setup.

DO NOT cancel any of the screens during the installation. It may take a few seconds for all screens to appear.

15