Wireless configuration for Windows® using the Brother installer application (Not available for MFC-5490CN and MFC-5890CN)

o If your network is configured for Authentication and Encryption, the following screen will appear. When configuring your Brother wireless machine, you must ensure that it is configured to match the Authentication and Encryption settings of your existing wireless network. Choose the Authentication Method and Encryption Mode from the pull-downs in each setting box. Then enter the Network Key and click Next.

4

Note

If you want to setup or configure additional WEP key indexes other than WEP key1, click Advanced.

If you do not know the Authentication or Encryption settings for your network, contact your network administrator.

If your wireless settings fail, an error message will appear during the installation of MFL-Pro Suite and the installation will be terminated. If you encounter this failure, go to step aon page 50 and setup the wireless connection again.

If you are using WEP and the LCD displayed ‘Connected’ but your machine is not found, make sure you entered the WEP key correctly. The WEP key is case sensitive.

p Click Next. The settings will be sent to your machine. The settings will remain unchanged if you click Cancel.

Note

If you want to manually enter the IP address settings of your machine, click Change IP Address and enter the necessary IP address settings for your network.

56