Wireless Configuration for Macintosh® using the Brother installer application (Not available for
m If the LCD shows Connected, the machine has successfully connected to your router or access point. You can now use your machine in a wireless network.
If the LCD shows Setting WLAN, Connecting WLAN, then Connection Failed, the machine has not successfully connected to your router or access point. Try starting from j again. If the same message is indicated again, reset the machine back to the default factory settings and try again. For resetting, see Restoring the network settings to factory default on page 124.
If the LCD shows Setting WLAN, then Connection Failed or Incorrect Mode, a session overlap was detected (see the table below). The machine has detected more than one router or access point on your network that has the
LCD messages when using the SES/WPS/AOSS control panel menu | 5 | ||
LCD shows | Connection status | Action |
|
Setting WLAN | Searching or accessing the access point, |
|
|
and downloading settings from the access | — |
| |
| point. |
|
|
|
|
|
|
Connecting SES |
|
|
|
Connecting WPS | Connecting to the access point. | — |
|
Connecting AOSS |
|
|
|
Connected | Connection succeeded. | — |
|
| Connection failed. | 1 Try starting j again. |
|
Connection Failed | (If this is shown after the LCD shows | 2 If the same message continues, |
|
Connecting SES, Connecting WPS or | reset the machine back to the factory |
| |
| Connecting AOSS.) | settings and try again. |
|
| A session overlap was detected. | Check that only one router or access |
|
|
| point has the |
|
|
|
| |
Incorrect Mode | A session overlap was detected. | mode or AOSS™ mode enabled and try |
|
|
| starting from j again. |
|
n Click Finish. |
|
|
|
You have completed the wireless network setup. If you would like to continue installing drivers and software necessary for operating your device, please choose Start Here OSX from the CD- ROM menu.
68