581B,C |
|
|
NOTES: |
| |
1. | If any of the original wire furnished must be replaced, it must | |
| be replaced with type 90 C wire or its equivalent. |
|
2. | Three phase motors are protected under primary | single |
phasing conditions.
3. Use copper conductors only.
4. TRAN is wired for 230 v unit. If unit is to be run with 208 v power supply, disconnect BLK wire from 230 v tap (ORN) and connect to 208 v tap (RED). Insulate end of 230 v tap.
LEGEND
C | — Contactor, Compressor | OFM | — Outdoor (Condenser) Fan Motor | |
CAP | — Capacitor | OLR | — Overload Relay | |
CLO | — Compressor Lockout | P | — Plug | |
COMP | — Compressor Motor | PL | — Plug Assembly | |
EQUIP | — Equipment | QT | — Quadruple Terminal | |
FPT | — Freeze Up Protection Thermostat | RS | — Rollout Switch | |
FU | — Fuse | SAT | — Supply Air Temperature Sensor | |
GND | — Ground | TRAN | — Transformer | |
HPS | — |
| Field Splice | |
HS | — |
| ||
I | — | Ignitor |
| Marked Wire |
IDM | — |
| ||
IFC | — | Indoor Fan Contactor |
| Terminal (Marked) |
IFM | — | Indoor Fan Motor |
| |
IGC | — Integrated Gas Unit Controller |
| Terminal (Unmarked) | |
LPS | — |
| ||
LS | — Limit Switch |
| Terminal Block | |
MGV | — Main Gas Valve |
| ||
|
| |||
Splice
Splice (Marked)
Factory Wiring Field Control Wiring Field Power Wiring
Accessory or Optional Wiring
To indicate common potential only; not to represent wiring.
C06147
Fig. 66 --- Typical Wiring Schematic and Component Arrangement (208/230-3-60 Shown)
54
