BT 3010 Executive Install the rechargeable batteries in the handset, Fit the handset belt clip

Models: 3010 Executive

1 62
Download 62 pages 46.94 Kb
Page 11
Image 11

Diverse 3010 Executive 22/3/01 12:02 pm Page 7

Diverse 3010 Executive – Edition 4 – 22 November ’00 - 3509

3Install the rechargeable batteries in the handset

The handset uses the two AA size rechargeable batteries, which are supplied. You must only use approved batteries. To install them, insert the batteries as indicated on the inside of the battery compartment or in the picture below. Slide the battery compartment cover shut. The battery compartment cover may be found in the packaging with the batteries.

Slide battery cover down and lift off.

4Fit the handset belt clip

Fit the belt clip onto the back of the handset.

Slot Tab

5Charge the handset batteries

When charging for the first time, we recommend that you let the batteries charge for the full 16 hours before making and receiving calls.

Battery display when inserting

or replacing a battery

When you replace the handset batteries with ones that have been fully charged, the battery indicator will not show full until the next charge cycle has been completed. Charge the handset until the batteries register full again. From then on the display will be correct.

Place the handset on the base. When charging, the battery level symbol shown on the display flashes.

Battery performance

After charging your Diverse 3010 Executive for the first time, subsequent charging time for the handset batteries is approximately 4-5 hours. Batteries and case may become warm during charging. This is normal.

SETTING UP

7

Page 11
Image 11
BT 3010 Executive manual Install the rechargeable batteries in the handset, Fit the handset belt clip, Battery performance