Hub Phone 1010 [3]DkBlue 13/4/06 5:44 pm Page 9
Hub Phone 1010 – Edition 3 – 13.04.06 – 7451
Getting started 9
3.On the hub:
Put the hub into registration mode, by pressing the wireless association key (located on the back of the hub).
The Power / in use LED flashes.
It is now ready to be associated with a new handset.
This registration mode lasts 90 seconds after pressing the button. Once this is completed the LED is switched off.
see page 46. If the battery runs out you will be cut off. You will need to recharge the handset before using it again.
During charging, the 
icon will scroll in the display.
Battery performance
To keep your batteries in the best condition, leave the handset off the base for a few hours at a time.
Running the batteries right down at least once a week will help them last as long as possible.
The charge capacity of rechargeable batteries will reduce with time as they wear out, giving the handset less talk/standby time.
Eventually they will need to be replaced. New batteries are available from the BT Hub Phone 1010 Helpline on 0845 600 7030.
