SERVICE (cont.)
START SWITCH
BREWERS W/FRESH LIGHT | P1258.50 |
| |
FIG. 10 START SWITCH | P939 |
|
Location:
On brewers w/out fresh light the start switch is located in the right front of the hood.
On brewers w/fresh light the start switch is located on the right side of the hood.
Test Procedure:
1.Disconnect the brewer from the power supply.
2.Disconnect the blue wire and the white/red wire from the switch terminals.
3.Check for continuity across the two terminals on the switch when it is held in the
If continuity is present as described, reconnect the blue wire and the white/red to the switch terminals. If continuity is not present as described, replace the switch.
Removal and Replacement:
1.Remove the blue wire and white/red from the start switch.
2.Remove round retaining nut from the front of the switch and remove switch and internal tooth lockwasher from the inside of the hood.
3.Push new switch with internal tooth lockwasher through the hole in the hood and secure with round retaining nut.
4.Refer to Fig. 11 when reconnecting the wires.
WHI/RED to | BLU to Timer P1 | |
Timer P3 | ||
|
P1259
FIG. 11 START SWITCH TERMINALS
Page 19 | 10478 061500 |
|
