Bunn CRTF5, CRT5 service manual SERVICE cont TIMER cont

SERVICE (cont.)

TIMER (cont.)

If voltage is present as described, the brew timer is operating properly. Reset the timer dial as required, to obtain the desired brew volume.

If voltage is not present as described, replace the timer.

Removal and Replacement:

1.Separate all connectors between the brewer wir- ing harness and the timer.

2.Remove the one #8-32 screw securing timer to component bracket.

3Install new timer circuit board as described in Late Model Timer section on the following pages.

4.Refer to Fig. 21 when reconnecting the wires.

5.Install the Timer Setting decal provided with the replacement timer kit, below the schematic on the inside of the front access panel.

6.Adjust the timer as required. Refer to Late Model Timer section on the following pages.

To Main Wiring Harness

WHI to Solenoid Valve

BLK to Solenoid Valve

OLD STYLE

P1136

FIG. 19 TIMER TERMINALS

Page 26 10478 061500