Bunn FMD-1 FMD-2 SERVICE cont, AUGER DRIVE COMPONENTS - FMD-2 cont, Auger Motor Terminals

SERVICE (cont.)

AUGER DRIVE COMPONENTS - FMD-2 (cont.)

Auger Drive Motor (Refer to Fig. 5 or 6)

1.Remove all hopper assemblies (20) and set aside for reassembly.

2.Remove the four #8-32 screws securing the hop- per support plate (19), remove plate and set aside for reassembly.

3.Remove the four #8-32 locking screws, located inside the dispenser housing on the front of the auger motor mounting panel (14), securing auger motor mounting bracket (15) and auger motor

(16)to the rear of the auger motor mounting panel

(14).

4.Disconnect the wires from the auger motor (16) to be removed.

5.Remove auger motor mounting bracket (15), au- ger motor (16) and dust seal (17) as an assembly.

6.Remove dust seal (17) from auger motor (16).

7.Remove the four #8-32 screws securing the auger motor to the auger motor mounting bracket.

8.Remove auger motor and discard.

9.Using four #8-32 screws install new auger motor

(16)on mounting bracket (15).

10.Install dust seal (17) on auger motor shaft.

11.Using four #8-32 locking screws install auger motor, dust seal and mounting bracket to the rear of the auger motor mounting panel (14)

12.Reconnect the wires to the terminals on the auger motor.

13.Install hopper support plate (19) and all hopper assemblies (20).

14.Refer to Fig. 7 when reconnecting wires.

LEFT	RIGHT
RED to WHI/ORN from
Control Board J3-2
BLK to GRN from
Control Board J3-4	BLK to GRN from
RED to WHI/RED from	Control Board J3-4
Control Board J3-3
FIG. 7 AUGER MOTOR TERMINALS		P1639

	BALLAST - FMD-1 & FMD-2
	FMD-1
		P1665
	J1
	12
		7
		J1
		J2
		J4
	J3
	FMD-2
	FIG. 8 BALLAST	P1666
18		29112 101598