SERVICE
AUGER DRIVE COMPONENTS (cont.)
If voltage is present as described, proceed to #5.
If voltage is not present as described, refer to the wir- ing diagrams and check the dispenser wiring harness.
5.With the wires removed from the motor to be tested. Check for continuity across the two ter- minals on the bottom of the auger motor.
If continuity is present as described, reconnect the wires to the terminals on the bottom of the auger motor, the auger motor is operating properly.
If continuity is not present as described, replace the auger motor.
Removal, Cleaning and Replacement
Hopper & Auger
1.Open the dispenser door and raise the top front cover.
2.Lift the front edge of hopper assy (21) over the tab on hopper support plate (20) and slide hop- per assembly out the front of the dispenser.
3.Remove hopper lid (1) and empty product.
4.Pull off the ejector elbow (14).
5.Remove auger disc assy (2) by pulling agitator support rod (4) towards agitator disc assy and lifting agitator disc assy from hopper (10).
6.Remove auger (12) by pulling it out the front of the hopper (10).
7.Remove auger drive shaft (5) by removing the retaining clip (6) from auger drive shaft.
8.Slide washer (8) and auger drive shaft bracket
(7) off of the auger drive shaft (5).
9.Slide auger drive shaft (5) from auger drive shaft bushing (3) and remove from hopper (10).
10.Remove locknut (9) from auger drive shaft bush- ing (3) and remove auger drive shaft bushing from hopper (10).
11.Wash components in a mild solution of dish de- tergent using a bristle brush when needed.
12.Rinse and dry each item thoroughly.
13.Check for damaged or broken components, re- place any if necessary and reassemble hopper assy.
1 |
| 4 |
2 |
|
|
3 | 6 | 11 |
| ||
|
| |
5 |
|
|
|
| 13 |
7 |
|
|
8 |
| 12 |
9 |
| |
| 14 | |
10 |
| |
|
| |
| 21 |
|
15 16 17 18 19 20 |
|
|
|
| P1200.35 |
FIG. 2 AUGER DRIVE & HOPPER DISASSEMBLY | ||
1. | Hopper Lid | 10. | Hopper |
2. | Agitator Disc Assy | 11. | Spring |
3. | Auger Drive Bracket | 12. | Auger Wire |
4. | Agitator Support Rod | 13. Auger Wire/Restrictor | |
5. | Auger Drive Shaft |
| (Optional) |
| Bushing | 14. | Ejector Elbow |
6. | Retainer Clip | 15. Wiring Harness Clamp | |
7. | Auger Drive Bracket | 16. | Auger Motor Bracket |
8. Washer | 17. | Auger Motor | |
9. | Locknut | 18. | Dust Seal |
|
| 19. | Shoulder Screw |
|
| 20. Hopper Support plate | |
|
| 21. | Hopper Assy |
13 | 27591 111596 |
|
