Bunn HC-3 Frother and Whipper Motor, Steam Collector #6-32 Screw Mixing Chamber, Ring

SERVICE (cont.)

FROTHER AND WHIPPER MOTOR

P1203.45

FIG. 11 FROTHER AND WHIPPER MOTOR

Location:

The frothers are located behind the dispenser door, mounted on the front of the front panel inside the whipper chamber.

The whipper motors are located on the back side of the front section of the front panel.

NOTE: The center position is for HC-3 Models only.

Test Procedure:

1. Disconnect the dispenser from the power source.

2. Disconnect the white/violet and white wires on the right motor, white/blue and white wires on the center motor or the white/red and white wires on the left motor from the black leads on the motors.

3. Press and hold the appropriate dispense switch and check the voltage across the disconnected harness wires with a voltmeter. Connect the dis- penser to the power source. The reading must be:

20

a)120 volts ac for two wire 120 volt models.

b)120 volts ac for three wire 120/208 volt or 120/ 240 volt models.

c)240 volts ac for two wire 240 volt models.

4.Disconnect the dispenser from the power source.

If voltage is present as described, replace the motor. If voltage is not present as described, refer to the wir- ing diagrams and check the dispenser wiring harness.

								1	2
	12
	11
	10	9	8	7	6	5	4	3
	FIG. 12 MIXING/WHIPPER CHAMBER								P1206
			COMPONENTS
1.	Steam Collector					7.	#6-32 Screw
2.	Mixing Chamber					8.	Receptical w/Seal
3.	Dispense Tip					9.	Teflon Washer
4.	Whipper Chamber					10.	O-Ring
5.	O-Ring					11.	#8-32 Acorn Nut
6.	Frother					12.	Motor Assy.

Removal, Cleaning and Replacement (Refer to Fig. 12):

1.Open the dispenser door.

2.Remove the steam collector (1) by pulling it for- ward and at the same time twisting it clockwise.

3.Pull the mixing chamber (2) out of the whipper chamber (4).

27591 031597