8.Rotate the valve ends of the cables through the notch at the bottom of the support tube and through the large hole in the support mount and floor board of the tractor. Attach the sup- port tube to the support mount as shown in Fig. 1. (NOTE: Take care to not cut cable cov- ering on sharp edges and be sure cable routing will not cause binding when attached to the valve).
9.Tighten all fasteners for handle controls and apply control decal to plate atop the support tube (Refer to Fig. 1).
10.ATTACHING VALVE TO LOADER FRAME:
Attach the valve mount to the outside surface of the pedestal on the mounting bracket of load on right hand side of the tractor. Use the 1/2” x 2 1/4” capscrews, 1/2” flatwashers, 1/2” lockwashers and 1/2” hex nuts as shown in Fig. 4.
11.Attach valve to valve mount using the (4) m8 x 1.25 x 20 Gr. 8.8 capscrews and m8 lock- washers as shown in Fig. 4. Be sure that the work ports are on top and the attaching ends of the spools are down.
12.It will be necessary to install the cable attaching kit on the cable in the order shown in Fig. 4. The nut, washer, flange and cap must be ran across the threaded part of the cable until they are hanging loose on the cable.
| Fig. 4 |
|
VALVE MOUNT TO PEDESTAL : |
|
|
(2) 1/2” X 2 1/4” CAPSCREWS |
|
|
(2) 1/2” FLATWASHERS |
|
|
(2) 1/2” LOCKWASHERS |
|
|
(2) 1/2” HEX NUTS |
|
|
VALVE MOUNT |
|
|
|
| LOADER |
|
| MOUNT BRACKET |
Hoses and Quick |
| PEDESTAL |
Disconnect Fittings Not |
|
|
Shown for Clarity! |
|
|
VALVE |
|
|
SPOOL END | “O” RING | VALVE TO VALVE MOUNT : |
| ||
| PIN | (4) m8 x 1.25 x 20 CAPSCREWS |
| JOINT | (4) m8 LOCKWASHERS |
|
| |
| JAMB NUT |
|
| CAP |
|
| FLANGE |
|
| SOCKET HEAD SCREW |
|
| WASHER |
|
| HEX NUT |
|
LIFT CIRCUIT CABLE | ATTACHMENT CIRCUIT CABLE | |
|
| Page 4 |
