3.Assemble the mount to the support tube and handle to the support tube (refer to Fig. 1). Leave all fasteners snug but not tight. position the assembly on the area of the floor board chosen and adjust the assembly to be sure the operator has complete and comfortable access to the control handle. (NOTE: The support mount may be rotated 1800 from posi- tion shown in Fig. 1 if necessary for better access to the controls). If the tractor has a floor matt, use the support mount as a template and mark the area around the base of the support mount where it contacts the matt. Cut the matt on the marked area and remove the cut out piece of matt.
4.It will be necessary to remove the support mount from the support tube to perform this step. Position support mount on the cab floor board and use the mount as a template. Drill four 3/8” holes in line with the four slotted holes in the support mount. Mark the center of the 1 1/4” hole in the support mount on the floor board as close as possible to the hole in the sup- port mount. Use a hole saw and cut a 1 1/4” hole that aligns with the large hole in the sup port mount (Refer to Fig. 1).
| Fig. 1 |
CONTROL HANDLE | DECAL |
| |
CONTROL HANDLE TO | SET SCREW |
SUPPORT TUBE : |
|
(2) 5/16” X 5 CAPSCREWS | 25H41276 |
(2) 5/16” FLATWASHERS |
|
(2) 5/16” LOCKWASHERS |
|
(2) 5/16” HEX NUTS |
|
| SUPPORT MOUNT TO |
| CAB FLOOR BOARD : |
CONTROL CABLES | (4) 3/8” X 2 3/4” CAPSCREWS |
| (4) 3/8” FLATWASHERS |
| (4) 3/8” LOCKWASHERS |
| (4) 3/8” HEX NUTS |
NOTCH AT BASE |
|
OF SUPPORT TUBE |
|
SUPPORT TUBE TO |
|
SUPPORT MOUNT : |
|
(2) 3/8” X 2 3/4” CAPSCREWS |
|
(2) 3/8” FLATWASHERS |
|
(2) 3/8” LOCKWASHERS |
|
(2) 3/8” HEX NUTS |
|
| DRILL (4) 3/8” HOLES |
SUPPORT MOUNT |
|
1 1/4” HOLE IN FLOOR BOARD | FLOOR BOARD |
|
Page 2
