Bush Hog 5045 manual Front Of Tractor

5.Attach the support mount to the floor board with (4) 3/8” x 2 3/4” Gr. 5 capscrews, 3/8” flat- washers, 3/8” lockwashers and 3/8” hex nuts provide in kit (Refer to Fig. 1).

6.Attach the control cables to the control handle body (Refer to Fig. 2). Remove the rubber boot from the control handle body. Insert the end of the cable into the control handle body enough to align the clevis on the end of the cable tab on the handle. Insert the pin through the clevis and tab and secure in place with the E-clip. Position the cable body so the groove in the cable body aligns with the cross drilled hole in the handle body. Insert metric bolt in cross drilled hole and through groove in cable body and secure with the metric nut.

	Fig. 2
	BOOT
	PIN
	E-CLIP
	HOUSING
CONTROL CABLE	GROOVE IN CONTROL CABLE

7.Attach the handle body to the support tube as shown in Fig. 1. Make sure the solid post in the control handle is positioned as shown in Fig. 3. (NOTE: The solid post position is crit- ical for the correct operation of this valve). Install the rubber boot. The knob on the con- trol handle must be rotated 1800 for this application. Loosen the setscrew in the base offline knob, rotate 1800 and retighten the set screw.

Fig. 3

FRONT OF TRACTOR

LIFT CIRCUIT

CONTROL CABLE

SOLID POST LOCATION

(NOTE: SOLID POST LOCATION IS CRITICAL FOR CORRECT VALVE OPERATION).

VALVE

ATTACHMENT CIRCUIT CONTROL CABLE

TOP VIEW OF HANDLE HOUSING

WITH BOOT REMOVED.

Page 3