Safety instructions during crane lift | Bush Hog HM2009, HM2008

Safety instructions during crane lift

Only use approved crane material. The machine must be in working position. Weight is stated on the drawing. Make sure that crane straps are securely fastened before lifting. Use a guide rope (not shown) to keep the machine in position.

Be careful - make sure that nobody stand under or near the machine when it is being lifted.

Fasten chain (A) on the machine as shown. Lift the machine in crane bracket (B). Use support rope, minimum 6 mm (1/4”) nylon rope at (C) and (D).

15

Image 17

Bush Hog HM2009, HM2008, HM2007 manual Safety instructions during crane lift

Contents

Bush HOG Congratulations HAY Mower Bush HOG Dealer Preparation Check List Safety Signs Signal Words Safety Alert Symbol Important Safety Precautions Child Labor Under 16 Years Old This Act SeeksOsha Regulations Models HM2007 HM2008 HM2009 Generally about supplementary equipment Model HM2007 Model HM2008 Model HM2009 Machine Identification Kg / lb General Safety Instructions SafetyPage Page Model Kg lb HM2007 415 HM2008 440 HM2009 465 Safety instructions during crane lift Page New Machine be careful HM2009 Model Color Preparation For UseDo the following before coupling the machine to the tractor Clip Pin Pawl Remove Clip Pin and Rotate Pawl Fitting of the suspension Mounting coupling Min mm Checking of PTO shaft length PTO shaftShortening of the shaft Model HM2009 8 mm 5/16 Model HM2007 13mm 1/2Model HM2008 11mm 7/16 Stabilizer Height of the suspensionLifting height If the distance C is too big, raise the lift arm at DPage Unhitching Transport UnhitchingTransport 80 ± 95 ± 60 ft./lbs 70 ft./lbs Knives cutting discs MaintenanceOperate with safety note the following Hole In Front Belt Guard Lubrication generally Belts Oil Filler Plug Oil level Plug D Oil cutterbarOil bevel gearbox Swath Roller Right-hand & Left-hand swath boards Optional equipmentRight-hand & Left-hand swath rollers Hillside Kit As Seen From Below Optional high skid Optional hillside kit Flat Blades Left cone Special flat knivesThrowing wings 2.8 mm Directions for repair Important, when fitting the gear to the machineHydraulic lifting cylinder Bevel gearboxPage Collar bearings illustration CutterbarFixing of collar bearing ilustration Synchronizing illustration Problem Possible Cause Correction Problem/Fault Analysis and Corrections Winter storage Torque Value Conversion ChartLubricants Assembly Instructions Support Leg U Bracket 16-40 mm Twisted Strut 12 40 mm Plow Bolt 12 35mm Plow Bolt Model HM2009 Model HM2008 Model HM2007 59 ft./lbs Working Direction GearboxWorking Direction Gearbox 10 35 mm 10 30 mm 10 30 mm 30 -10.5 3 mm 10 -30 mm 30 10.5 3 mm Optional Equipment Safety Decals Page Page Bush HOG