10 30 mm 30 -10.5 3 mm | Bush Hog HM2009, HM2008, HM2007 instruction

18.Attach front edge rail to frame. (Figure 14)

19.Install top support over curtain and frame. (Figure 16) Note that pawl must be inserted into place

Figure 14

before inner end of support is bolted to the upright bracket. (Refer to Figures 5 & 11) Fasten curtain to frame with bolts and flat washers as shown. (Figure 16)

10 - 30 mm

30 -10.5 - 3 mm

			Outer
			End Rail
			Outer End
	10 - 40 mm		Outer End
	10 - 40 mm		Lower Rail
			Lower Rail

Figure 15

10 -30 mm

30 -10.5 - 3 mm

54

Image 56

Bush Hog HM2009, HM2008, HM2007 manual 10 30 mm 30 -10.5 3 mm

Contents

Bush HOG Congratulations HAY Mower Bush HOG Dealer Preparation Check List Safety Alert Symbol Safety Signs Signal Words Important Safety Precautions Child Labor Under 16 Years Old This Act SeeksOsha Regulations Models HM2007 HM2008 HM2009 Model HM2007 Model HM2008 Model HM2009 Generally about supplementary equipment Machine Identification Kg / lb Safety General Safety InstructionsPage Page Model Kg lb HM2007 415 HM2008 440 HM2009 465 Safety instructions during crane lift Page New Machine be careful HM2009 Model Color Preparation For UseDo the following before coupling the machine to the tractor Clip Pin Pawl Remove Clip Pin and Rotate Pawl Mounting coupling Fitting of the suspension Min mm Checking of PTO shaft length PTO shaftShortening of the shaft Model HM2009 8 mm 5/16 Model HM2007 13mm 1/2Model HM2008 11mm 7/16 Height of the suspension StabilizerLifting height If the distance C is too big, raise the lift arm at DPage Unhitching Transport UnhitchingTransport 80 ± 95 ± 60 ft./lbs 70 ft./lbs Knives cutting discs MaintenanceOperate with safety note the following Hole In Front Belt Guard Belts Lubrication generally Oil Filler Plug Oil level Plug D Oil cutterbarOil bevel gearbox Swath Roller Right-hand & Left-hand swath boards Optional equipmentRight-hand & Left-hand swath rollers Hillside Kit As Seen From Below Optional hillside kit Optional high skid Flat Blades Left cone Special flat knivesThrowing wings 2.8 mm Important, when fitting the gear to the machine Directions for repairHydraulic lifting cylinder Bevel gearboxPage Cutterbar Collar bearings illustrationFixing of collar bearing ilustration Synchronizing illustration Problem/Fault Analysis and Corrections Problem Possible Cause Correction Winter storage Torque Value Conversion ChartLubricants Assembly Instructions 16-40 mm Support Leg U Bracket 12 40 mm Plow Bolt 12 35mm Plow Bolt Twisted Strut Model HM2009 Model HM2008 Model HM2007 59 ft./lbs Working Direction GearboxWorking Direction Gearbox 10 35 mm 10 30 mm 10 30 mm 30 -10.5 3 mm 10 -30 mm 30 10.5 3 mm Optional Equipment Safety Decals Page Page Bush HOG