Model HM2009 Model HM2008 Model HM2007 | Bush Hog specification

10.Remove pin from top of three point lift frame to allow instrallation of stabilizer cylinder assembly.

(Figure 8)	Attach Hydraulic Hose With Clamp

Figure 8 Cylinder Mounting Hole Locations

Model HM2009 Models HM2007 & HM2008

Before mounting stabilizer, pull out the piston/rod of the hydraulic cylinder.

11.Remove pin from lower connection link and stop link to allow installation of lower end of stabilizer.

12.Pin stabilizer in appropriate top hole according to size of cutter bar. (Figure 8) Also refer to decal on machine.

13.Pull out hydraulic cylinder rod (Open hydraulic valve and release poppet in end of hydraulic line) and assemble to connection link and stop link at lower end. Refer to photograph and illustration for correct hole. (Figure 9)

Figure 9

215 mm (8-1/2”) 290 mm (11-1/2”)

Model HM2009

Model HM2008

Model HM2007

50

Image 52

Bush Hog manual Model HM2009 Model HM2008 Model HM2007

Contents

Bush HOG Congratulations HAY Mower Bush HOG Dealer Preparation Check List Safety Alert Symbol Safety Signs Signal Words Important Safety Precautions Osha Regulations This Act SeeksChild Labor Under 16 Years Old Models HM2007 HM2008 HM2009 Model HM2007 Model HM2008 Model HM2009 Generally about supplementary equipment Machine Identification Kg / lb Safety General Safety InstructionsPage Page Model Kg lb HM2007 415 HM2008 440 HM2009 465 Safety instructions during crane lift Page New Machine be careful HM2009 Do the following before coupling the machine to the tractor Preparation For UseModel Color Clip Pin Pawl Remove Clip Pin and Rotate Pawl Mounting coupling Fitting of the suspension Min mm Shortening of the shaft PTO shaftChecking of PTO shaft length Model HM2008 11mm 7/16 Model HM2007 13mm 1/2Model HM2009 8 mm 5/16 Height of the suspension StabilizerLifting height If the distance C is too big, raise the lift arm at DPage Transport Transport UnhitchingUnhitching 80 ± 95 ± 60 ft./lbs 70 ft./lbs Operate with safety note the following MaintenanceKnives cutting discs Hole In Front Belt Guard Belts Lubrication generally Oil Filler Plug Oil bevel gearbox Oil cutterbarOil level Plug D Swath Roller Right-hand & Left-hand swath rollers Optional equipmentRight-hand & Left-hand swath boards Hillside Kit As Seen From Below Optional hillside kit Optional high skid Flat Blades Throwing wings Special flat knivesLeft cone 2.8 mm Important, when fitting the gear to the machine Directions for repairHydraulic lifting cylinder Bevel gearboxPage Cutterbar Collar bearings illustrationFixing of collar bearing ilustration Synchronizing illustration Problem/Fault Analysis and Corrections Problem Possible Cause Correction Winter storage Lubricants Conversion ChartTorque Value Assembly Instructions 16-40 mm Support Leg U Bracket 12 40 mm Plow Bolt 12 35mm Plow Bolt Twisted Strut Model HM2009 Model HM2008 Model HM2007 59 ft./lbs Working Direction Gearbox GearboxWorking Direction 10 35 mm 10 30 mm 10 30 mm 30 -10.5 3 mm 10 -30 mm 30 10.5 3 mm Optional Equipment Safety Decals Page Page Bush HOG