CHAPTER 2
INSTALLATION
Only qualified personnel should install or service this unit.
To install the HSIM-G you need the following items:
•Antistatic wrist strap
•Phillips screwdriver
Before attempting to use the HSIM-G you should be familiar with the IEEE 802.3z specification. The network installation must meet the guidelines contained in the draft specification to ensure satisfactory performance of the equipment.
2.1UNPACKING THE HSIM-G
The HSIM-G and the host module or device (host platform) are sensitive to static discharges. Use a grounding strap and observe all static precautions during this procedure. Failure to do so could result in damage to the HSIM-G or host platform.
Unpack the HSIM-G as follows:
1.Remove the shipping box material covering the HSIM-G.
2.Carefully remove the module from the shipping box. Leave the module in its non-conductive bag until you are ready to install it.
3.Attach the antistatic wrist strap. If the HSIM-G is to be installed in a standalone device, refer to the instructions on the antistatic wrist strap package. If the HSIM-G is to be installed in an interface module, refer to the applicable interface module User’s Guide.
4.After removing the module from its non-conductive bag, visually inspect the device. If you notice any signs of damage, contact Cabletron Systems immediately. Refer to Section 1.3 for instructions.
HSIM-G01/G09 User’s Guide | 2-1 |
