Cabletron Systems HSIM-G01 manual HSIM-G09 Connection Using Multimode Cable

Connecting to the Network

To remove the SC connector, from the HSIM-G, carefully pull the connector out of the port. It may need to be wiggled gently to release the latching keys.

If a link has not been established, refer to Chapter 3 before contacting Cabletron Systems. Refer to Section 1.3 for details on getting help.

2.3.2HSIM-G09 Connection Using Multimode Cable

NOTE

When using premises multimode fiber cable for the HSIM-G09 (long wave length transceiver), connect Launch Mode Conditioning cable as detailed in the following procedure. This procedure is not needed when connecting single mode fiber cable to the HSIM-G09. Do not attach Launch Mode Conditioning cable if the installation is not using an HSIM-G09 with multimode fiber cable.

Launch Mode Conditioning cable is available through Cabletron Systems.

To connect the HSIM-G09 to the network using multimode fiber, perform the following steps:

1.Connect Launch Mode Conditioning cable to the multimode fiber on both ends of the premises cable before connecting the HSIM-G09 to the premises cabling. See Figure 2-5.

Launch Mode

Conditioning

Cable

Installed premises

multimode fiber cable Launch Mode Conditioning

Cable

Long Wavelength	Connect the ends of the	Long Wavelength
Gigabit Fiber Device	premises cabling to the	Gigabit Fiber Device
	Launch Mode
	Conditioning Cables
		mmfLWct

Figure 2-5 Launch Mode Conditioning Cable Connection for the HSIM-G09

2.Once the Launch Mode Conditioning cable is connected to the ends of the premises multimode fiber cable, return to Section 2.3.1 to complete the installation to the HSIM-G09 device.

HSIM-G01/G09 User’s Guide 2-9