Chapter 2: Installation

2.2INSTALLING AN HSIM-G

You can install an HSIM-G in any Cabletron Systems device that supports HSIM technology (e.g., 2E42-27, 6E132-25).

NOTE

Refer to the release notes for the version of firmware running on the host platform to ensure that the HSIM-G is supported. “Host platform” is used to designate the interface module or standalone device into which the HSIM-G is installed.

The following sections provide instructions for installing an HSIM-G in an interface module or in a standalone device. Refer to your specific interface module or standalone device documentation for exact HSIM slot and connector locations. Refer to Section 2.2.1 to install the HSIM-G in an interface module, and Section 2.2.2 to install the HSIM-G in a standalone device.

2.2.1Installing an HSIM-G in an Interface Module

To install an HSIM-G in an interface module that supports HSIM technology, perform the following steps.

1.Disconnect any network cables connected to the ports of the interface module.

Note the ports of the interface module that have cables

TIP attached to them. Write down the port numbers and label the cables to make it easier to reattach the network properly after the installation.

2.Attach the antistatic wrist strap (refer to the instructions outlined on the interface module User’s Guide).

3.If the module is in a chassis, unlock the top and bottom plastic locking tabs of the module faceplate, and remove the module from the chassis.

4.Lay the module down with the internal components facing up.

5.Refer to Figure 2-1and remove the two faceplate mounting screws and the HSIM coverplate. Save the screws.

6.Refer to Figure 2-1and remove the four standoff screws. Save the screws.

2-2

HSIM-G01/G09 User’s Guide

Page 16
Image 16
Cabletron Systems HSIM-G01 manual Installing AN HSIM-G, Installing an HSIM-G in an Interface Module