Cadillac 2009 owner manual Voice Pass-Thru, Dual Tone Multi-Frequency Dtmf Tones

To Transfer Audio to the In-Vehicle Bluetooth System

The cellular phone must be paired and connected with the Bluetooth system before a call can be transferred. The connection process can take up to two minutes after the key is turned to the ON/RUN or ACC/ACCESSORY position.

During a call with the audio on the cell phone, press b g for more than two seconds. The audio switches from the cell phone to the vehicle.

Voice Pass-Thru

Voice Pass-Thru allows access to the voice recognition commands on the cell phone. See the cell phone manufacturers user guide to see if the cell phone supports this feature. This feature can be used to verbally access contacts stored in the cell phone.

1.Press and hold b g for two seconds. The system responds with “Ready” followed by a tone.

2.Say “Bluetooth”. The system responds with “Bluetooth ready” followed by a tone.

3.Say “Voice”. The system responds with “OK, accessing <phone name>”.

•The cell phone’s normal prompt messages will go through its cycle according to the phone’s operating instructions.

Dual Tone Multi-Frequency (DTMF) Tones

The in-vehicle Bluetooth system can send numbers and numbers stored as name tags during a call. This is used when calling a menu driven phone system. Account numbers can be programmed into the phonebook for retrieval during menu driven calls.

Sending a Number During a Call

1.Press b g . The system responds with “Ready” followed by a tone.

2.Say “Dial”. The system responds with “Say a number to send tones” followed by a tone.

3.Say the number to send.

•If the system clearly recognizes the number it responds with “OK, Sending Number” and the dial tones are sent and the call continues.

•If the system is not sure it recognized the number properly, it responds “Dial Number, Please say yes or no?” followed by a tone. If the number is correct, say “Yes”. The system responds with “OK, Sending Number” and the dial tones are sent and the call continues.

3-75