Cadillac 2009 owner manual To adjust the vertical aim

Headlamp aiming is done with the vehicle’s low-beam headlamps. The high-beam headlamps will be correctly aimed if the low-beam headlamps are aimed properly.

To adjust the vertical aim:

1.Open the hood. See Hood Release on page 6-13 for more information.

2.Locate the center of the projector lens of the low-beam headlamp.

3.Record the distance from the ground to the center of the projector lens of the low-beam headlamp.

4.At a wall, measure from the ground upward (A) to the recorded distance from Step 3 and mark it.

5.Draw or tape a horizontal line (B) on the wall the width of the vehicle at the height of the mark in Step 4.

Notice: Do not cover a headlamp to improve beam cut-off when aiming. Covering a headlamp may cause excessive heat build-up which may cause damage to the headlamp.

6.Turn on the low-beam headlamps and place a piece of cardboard or equivalent in front of the headlamp not being adjusted. This allows only the beam of light from the headlamp being adjusted to be seen on the flat surface.

6-49