[ Trimming
You can cut out a portion of a recorded image and save it as a new image file.
Trimming Area
Trimming Area Display
Recorded pixels after trimming
Select [Trimming].
●Press the n button, select the 1 tab and [Trimming], then press the m button.
Select an image.
●Press the qr buttons or turn the  dial, select the image and press the m button.
Adjust the trimming area.
A frame will appear around the portion of the image to be trimmed.
The original image will display in the upper left and the trimmed image will display in the lower right.
●If you move the zoom lever to the left or right, you can change the frame size.
●If you press the opqr buttons, you can move the frame.
●If you press the l button, you can change the vertical/horizontal orientation of the frame.
●In an image with a detected face, a gray frame will appear around faces located in the upper left of the frame, and the frame
can be used for trimming. You can switch between frames by turning the  dial.
●After pressing the m button, press the qr buttons or turn the  dial to select [OK], and press the m button.
Save as a new image and display.
●Perform Steps 4 and 5 on p. 121.
•
, 
and 
images cannot be trimmed.
•Trimming is only possible for images shot at aspect ratio 4:3 (vertical 3:4).
•The number of recorded pixels in a trimmed image will be smaller than before trimming.
