AXIS 1610 User’s Manual | Section 4: Management & Configuration | 49 |
|
|
|
Using the Test Button
The test button is located on the front right hand side of the AXIS 1610 and is used for resetting the AXIS 1610 parameters to the factory default settings.
Factory Default | Follow the instructions below to reset the AXIS 1610 to the | |
Settings | factory default settings: | |
| 1. | Remove the external power supply to switch off the AXIS 1610. |
| ||
| 2. | Press and hold down the test button, while you plug the external |
|
| power supply back in. Continue to hold down the test button, |
|
| until the network indicator begins to flash at one second |
|
| intervals. This should take at least 5 seconds. |
| 3. | Release the test button and wait until the network indicator |
|
| flashes at least five times. |
| 4. | Press and hold the test button again until the network indicator |
|
| remains constantly lit. |
| 5. | Restart the AXIS 1610 by disconnecting and reconnecting the |
|
| external power supply. |
| The AXIS 1610 is now reset to factory default settings. | |
Note: | ❏ | All parameters except the IP Address (IP_ADDR.) and the DHCP |
|
| Enable/Disable (DHCP_ENB) parameters are reset. If you want to |
change these parameters, please use any of the tools presented in Configuration Overview, on page 32.
