AXIS 1610 User’s Manual | Section 5: Upgrading the Firmware | 51 |
|
|
|
5.Wait for the flash loading operation to finish. This normally takes 1 to 4 minutes. The unit automatically restarts with the new print server software.
6.Log out using the command quit, bye or exit depending on your FTP version.
Notes: ❏ If the upgrading process fails, just repeat the instructions presented above.
❏If you lose contact with the AXIS 1610 after an upgrading failure, just restart the AXIS 1610 to restore contact.
❏If the network diode flashes at regular half second intervals, the AXIS 1610 cannot process any print jobs. In order to leave this state, you must repeat the instructions above.
Upgrading using This method is recommended for upgrading the flash memory in AXIS NetPilot networks supporting the IPX protocol. An Upgrade Wizard will
guide you through the necessary procedures.
Follow the instructions below to upgrade your print servers:
1.Obtain the firmware file. You can download print server software from the Axis web site at http://www.axis.com
2.Put the file in the AXIS NetPilot ‘Upgrade’ folder. This folder resides in the same folder as the AXIS NetPilot program and was created when AXIS NetPilot was installed on your client.
3.Start the Upgrade Wizard by clicking on the Upgrade icon on the AXIS NetPilot toolbar.
4.Proceed the installation by following the instructions that are presented to you in the Upgrade Wizard.
If you need more information, please refer to AXIS NetPilot on- line help.
